Steering wheel — removal and installation 1. Disconnect the battery from the ground and wait at least 1 min. 2. Set the wheels to the driving position in a straight line 3. Remove the airbag...
Steering column — removal and installation Removing 1. Remove the steering wheel. 2. Move the column to the lower position and lock with a key. 3. Loosen the screw and remove the speaker control lever...
Steering gear covers — replacement 1. Disconnect the tie rod end. 2. Remove the clamps and remove the cover (see photo). 3. Clear steering draft and establish a cover upside-down.
Steering gear — removal and installation 1. Set the wheels to the straight ahead position. Remove the ignition key from the lock. 2. Remove the subframe (see above). 3. Remove the rear engine mount...
Removing air from the hydraulic booster circuit 1. The air from the hydraulic booster circuit is removed at room temperature. It is forbidden to perform this procedure phase after the trip. The bleed...
Tie rod ends — removal and installation 1. Raise the front of the car and place it on stands. Remove the wheel. 2. Loosen the tie rod end locknut ¼ turn (see photo). Measure the length of the visible...
Tie rods — removal and installation 1. Remove the tie rod end. 2. Remove the latches and remove the wing protection panel. 3. Remove a cover of draft, having removed collars. 4. Turn the wheel...
Wheel alignment — general information An accurate check of the wheel alignment is carried out in a car service. The camber and angle of inclination of the axis of rotation are provided by the...