Car doors and windows Opel Corsa B

Removal and installation of facing of doors
Cars from 09.1998 of release can be equipped with a side airbag built into the sides of the backrests of the driver's and front passenger's seats. Seats with...

Removal and installation of glass of a forward door
Removing 1. Remove facing of a door with a sealing film. Be careful not to tear the film, otherwise it will need to be replaced. 2. Close the window...

Removal and installation of glass of a back door (Corsa model)
Removing 1. Remove the inner lining of the door with foil. 2. Remove the rear window trim. Removing the rear door glass trim 3. Fully open the window. 4....

Removal and installation of a window regulator
Installation of manual and electric windows is the same. The electric window regulator is electronically controlled, i.e. by briefly pressing the switch (less...

Removal and installation of the external door handle
Removing 1. Remove facing of a door. 2. Remove the protective film. Make sure that the film does not tear. Seal the torn film or replace it. 3. Turn out bolts...

Removal and installation of the cylinder of the lock of a forward door
Removing 1. Remove the door handle. To remove the lock cylinder, insert the key into the lock. 2. Remove retaining ring (5). Front Door Lock Cylinder Assembly...

Removal and installation of the door lock
Removing 1. Remove facing of a door. 2. Remove the protective film. Make sure that the film does not tear. Seal the torn film or replace it. 3. Turn out bolts...

Frost protection of locks and seals
1. Lubricate the lock cylinder. For this purpose, special grease OPEL-ET-No. 90018813, a tube 8 cm long and a syringe are used (OPEL-ET-№ 90020227), and a...

Removal, installation and adjustment of the door
Removing 1. Remove facing of a door. 2. Disconnect the connectors of the electrical wiring of the e / motors of the power window drive, adjustment of the...

Removing and installing the tailgate (Corsa and Tigra models)
Removing To facilitate the subsequent installation of electrical wiring and hoses, tie cords to their ends before removing them. The cord remains in the...

Removal and installation of the tailgate lock (Corsa and Tigra models)
Corsa models 1. Unscrew the tailgate lift cord holders (arrows) from the interior lining. Lift cord holders 2. Remove an internal upholstery from clamps. 3....

Removing, installing, disassembling and assembling the outer handle and tailgate lock cylinder (Corsa model)
Removing 1. Unscrew the tailgate lift cord holders from the interior lining. 2. Remove an internal upholstery from clamps. 3. Disconnect the lock drive rod...

Sliding roof panel
Sliding Roof Panel Installation Components 1 - Side visor 2 - Brush 3 - drive cover 4 - Crank drive 5 - Drive handle 6 - Water drain hose 7 - Drive housing 8 -...