Car steering Opel Corsa B

Removal and installation of a steering wheel
Removing The instructions below only apply to steering wheels without airbags. For safety reasons, the airbag must be removed at a workshop. 1. Disconnect the...

Removal and installation of steering draft
Removing 1. Remove the tie rod end. 2. Disconnect both collars and remove a casing from steering draft. Tie Rod 3. Remove the tie rod from the steering gear...

Removal and installation of a tip of steering draft
The tie rod ends are cut as right-hand, current and left-hand threads. Removing 1. Mark the position of the front wheels in relation to their hubs so that the...

Removal and installation of the power steering fluid reservoir
1. Remove the pinch bolt (1) power steering fluid reservoir holder. Power Steering Fluid Reservoir Coupling Bolt and Clamps 2. Remove the holder. 3. If the...

Removal of air from the hydraulic path of the power steering
Air from the power steering hydraulic path should be removed after opening the path. The power steering pump must not run dry. 1. With the engine stopped,...

Removal and installation of the power steering pump
Removing 1. Remove the air filter housing and air intake sleeve. 2. Remove the V-belt (see chapter Vehicle settings and routine maintenance ). 3. Disconnect...

Wheel alignment
General information The rear wheel alignment angles are set at the factory and are not among the parameters under control. The angles of the front wheels...