Vehicle Maintenance Specifications Specifications Recommended lubricants and fluids Listed below are the lubricants and fluids recommended by the vehicle manufacturer at the time of writing this...
Schedule of ongoing maintenance The intervals of routine maintenance of the vehicle specified in this Section are designed for the independent performance by the owner of the vehicle of all...
General information about maintenance This Chapter has been compiled to help the car owner keep his vehicle in a state of maximum readiness for operation, getting from it an effective return in...
General information about settings and adjustments Entitled «settings» this Manual does not imply a single procedure for adjusting any of the parameters of the car's systems, but a whole range of adjustments to...
Fluid level checks Some special maintenance procedures that require additional fluid level checks are also described below. Check under the vehicle regularly for signs of fluid...
Changing the engine oil and oil filter Replacement is carried out every year. All engines When changing the oil, the oil filter should also be replaced. Under severe operating conditions, such as...
Removal of sludge from the diesel engine fuel filter Release until 08.1997 - every year, release from 09.1998 - every 2 years. Before beginning any fuel filter maintenance procedures, thoroughly wipe the area...
Checking the Status of Components A condition check is carried out every year. A wide range of engine failures is associated with malfunctioning of the cooling system. On models equipped with...
Checking, maintenance and charging The check is carried out every year. The factory package of all the models considered in this manual includes a sealed type battery that does not require...
Checking the condition and replacing the brushes A condition check is carried out every year. The condition of the windshield wiper assemblies should be checked regularly in accordance with the vehicle's...
Check of system of release of the fulfilled gases The check is carried out every year. The check should be carried out with the engine cold. You will need a source of compressed air to test. 1. Start the...
Checking the brake system Remember that the dust generated during the operation of the brake mechanisms may contain asbestos, which is extremely harmful to human health. Never blow off...
Checking electrical equipment Electrical equipment is checked every year. 1. Check the proper functioning of all on-board electrical consumers, including headlights, direction indicators,...
Checking and adjusting idle speed and maximum speed Models with a diesel engine up to 08.1997, issue. (Every year). To adjust the idle speed of a diesel engine, a tachometer operating on the principle of a...
Filter element replacement The air cleaner is installed in the right front corner of the engine compartment. 1. Open the collar (2) and disconnect the air hose from the air filter...
Fuel filter replacement Petrol models The fuel filter is located on the bottom of the car, on the right, next to the fuel tank. The special HAZET 4501-1 pliers are required to replace...
Checking the composition of the exhaust gases The composition of exhaust gases is monitored using a special gas analyzer and is usually included in the number of regular checks carried out when the car...
Lubrication of locks, hinges and stops 1. Walk around the machine and lubricate the hinges and stops on the doors, hood and trunk lid with light motor oil. 2. Lubricate the hood latch and the...
Inspection of suspension components Suspension and steering components should be checked regularly as wear or damage can shorten tire life, reduce vehicle handling and increase fuel consumption....
Replacing spark plugs In the electronic ignition system, a very high voltage is generated! Be careful, observe all necessary precautions when servicing any system components,...
Checking clutch pedal adjustment Examination Clutch adjustment must be carried out on Corsa and Tigra models without automatic adjustment. As the clutch wears, the pedal moves up. 1. Measure...
Brake Fluid Replacement Brake fluid is hygroscopic, i.e. it can absorb moisture, for example, through the pores of the brake hose and the reservoir vent. As a result, the boiling...
Automatic fluid change (ATF) 1. Drain the ATF into a suitable container. 2. Replace the drain plug O-ring and tighten the plug firmly 15 ÷ 20 Nm. 3. Fill with approximately 5.0 liters of...