Removing and installing the HVAC fan drive motor

Corsa C models

1. Disconnect the wire from the negative battery terminal (see chapter 5).

2. Remove the main glove box (see chapter 11).

3. Remove the lower lining of the instrument panel from the side of the front passenger's footwell (see chapter 11).

4. Unlock and remove the air supply hose to the passenger footwell.

5. Remove the side decorative panel of the console section of the instrument panel (see chapter 11).

6. Disconnect the electrical connector and remove the 5 bolts securing the fan motor assembly (see resist. illustration).



7. Press the latches (see resist. illustration) and remove the HVAC fan motor.




8. Installation is carried out in the reverse order of removal.

Meriva Models

9. Disconnect the wire from the negative battery terminal (see chapter 5).

10. Remove the main storage box (see chapter 11).

11. Remove the decorative panel of facing of the panel of devices from outside a foot well of the forward passenger (see chapter 11).

12. Unlock and remove the air supply hose to the passenger footwell.

13. Unlock and disconnect the electrical wiring connectors of the fan drive motor (see resist. illustration).



14. Turn out a fixing bolt, wring out 6 holders (see illustration 12.13) and lift the motor down.

15. Installation is performed in the reverse order of removal. At the same time, replace 2 holders on the bulkhead of the engine compartment with screws.