Interior (internal elements) of car Opel Corsa C

Care of vinyl trim elements
1. Do not use detergents, caustic soda, or petroleum-based cleaners when cleaning vinyl panels. A warm solution of soap and water works well for this purpose....

Upholstery and carpet care
1. Remove carpets and mats every 3 months and clean interior upholstery panels. If necessary, this procedure can be performed more frequently. You can use a...

Removing and installing sun visors
1. Release the edge of the sun visor from the fixed bracket (see resist. illustration), remove the 2 screws that secure the pivot bracket and remove the visor....

Removing and installing ceiling handle and eyeglass case
Note: On some models, a special case for glasses can be attached on the driver's side instead of a handle. It comes off just like the handle. 1. Fold the...

Removal and installation of a saloon rear-view mirror
1. On models not equipped with a rain sensor, to remove the interior rear-view mirror, it is necessary to press the locking clip with a screwdriver (see...

Removal and installation of the main glove box
1. Turn out 2 bottom screws of fastening of a ware box (see resist. illustration). 36.1. Lower (arrows A) and upper (arrows B) main glove box fixing screws: 1....

Removal and installation of an anther of the lever of a gear change (models with manual transmission)
1. Using a plastic wedge, press the gearshift boot frame away from the center console (see resist. illustration). 37.1. Press the anther frame (1) gear lever...

Removal and installation of the center console
Corsa models 1. On AT equipped models, move the selector lever to the «D». 2. Pull out the front ashtray tray (and with the appropriate configuration and rear)...

Panels of lateral facing of console section of the panel of devices
1. On Corsa C models, remove the center console ( see Section 38 ). 2. Remove 2 screws (see resist. illustration) and remove the appropriate instrument panel...

The lower decorative cover of the panel of devices under a steering column
Corsa C models 1. Set the steering column to its highest position (see chapter « Controls and methods of operation »). 2. Using a screwdriver, press out the 2...

Dashboard trim strip (Meriva models)
1. Open the main glove box, remove the 2 screws securing the trim strip (see resist. illustration) and separate it from the instrument panel. 41.1. Left (1)...

Removal and installation of interior trim thresholds
Corsa C, 5-door hatchback 1. Remove the rear seat back ( see Section 55 ). 2. Turn out the screw of fastening of the back panel of finishing of a threshold...

Removing and installing A-pillar trim
Top finish Attention: When equipping a car with head airbags, strictly follow the safety precautions ( see Chapter 10, Section 11 )! Corsa models 1. Disconnect...

Removal and installation of B-pillar trim
Attention: When equipping a car with head airbags, strictly follow the safety precautions ( see Chapter 10, Section 11 )! Corsa C, 3-door hatchback 1....

Removal and installation of the rear side trim (3-door hatchback)
1. Disconnect the front door door opening rubber seal from the B-pillar ( see Section 30 ). 2. Remove the threshold trim ( see Section 42 ). 3. Remove the rear...

Removal and installation of finishing of pillars C and D
Attention: When equipping a car with head airbags, strictly follow the safety precautions ( see Chapter 10, Section 11 )! Corsa C models 1. Separate the rubber...

Dashboard lower trim panels (Meriva models)
Passenger foot well 1. Remove the main storage box ( see Section 36 ). 2. Remove the decorative cover and remove the fixing screw (see resist. illustration)....

Removal and installation of an overlay of a threshold of a door of a back
Note: This procedure is described below using the Corsa C model as an example. On Meriva models, the removal / installation of the trim is carried out in a...

Removal and installation of furnish of sidewalls of a luggage space
Corsa C models 1. Open the tailgate and remove the luggage compartment shelf (see chapter «Controls and methods of operation», Section 17 ). 2. On 5-door...

Removing and installing the front seat belt (Corsa C)
Corsa C, 3-door hatchback 1. Remove the rear side trim ( see Section 45 ). 2. Remove the decorative cover of the upper anchor belt, unscrew the fixing screw...

Upper seat belt anchor height adjuster (Corsa C)
Corsa C, 3-door hatchback 1. Separate the upper anchor bracket from the adjuster guide on the B-pillar. 2. Remove the B-pillar top trim ( see Section 44 ). 3....

Removal and installation of a back seat belt (Corsa C)
Corsa C, 3-door hatchback 1. Remove the rear seat and rear seat back ( see Section 55 ). 2. Remove the decorative cover of the upper seat belt anchor, unscrew...

Removal and installation of locks of back seat belts (Corsa C)
1. Fold down the rear bench seat (see chapter «Controls and methods of operation», Section 12 ). 2. Remove the fixing screw (see resist. illustration) and...

Removal and installation of a forward seat
Note: This procedure is described below using the Corsa C model as an example. On Meriva models, the removal / installation of the front seats is carried out...

Removal and installation of a back seat
See also Chapter «Controls and methods of operation», Section 12 . Corsa C models Note: The procedure for removing/installing the two-section rear bench seat...

Bench seat back support bracket (Corsa C)
1. Remove the luggage compartment shelf (see chapter «Controls and methods of operation», Section 17 ). 2. Fold down the back of the rear bench seat (see...