Car wheel suspension Opel Corsa C

Suspension and steering specifications
suspension type: Front suspension - Independent, with MacPherson struts, gas-charged shock absorbers and anti-roll bar Rear suspension - semi-independent, with...

General information about car suspension
Attention: When assembling the elements of the suspension and steering structure, it is imperative to comply with the requirements for the tightening force of...

Removal and installation of a forward shock-absorber rack
1. The design of the front shock absorber strut is shown in resist. illustrations. 2.1. Front shock absorber design: 1. Top fixing nut; 2. Top thrust washer;...

Dismantling, removal and installation of the front shock absorber
Attention: For dismantling of a shock-absorber rack use only serviceable tool. Never unscrew the shock absorber nut unless the spring is securely compressed...

Removal and installation of a rotary fist
1. Remove the corresponding wheel and loosen the hub nut ( see chapter 8 ). 2. Remove the brake shoe guide and front wheel brake disc ( see chapter 9 ). 3....

Removal and installation of the hub assembly of the front wheel
Attention: The wheel bearings are pressed into the steering knuckles! Removal and installation of the bearing must be carried out only using a hydraulic press...

Removal and installation of the transverse front arm
Note: Each time the transverse arm is removed, check the condition of its ball joint and the reliability of fastening to the steering knuckle ( see Chapter 8,...

Removal and installation of the front subframe
1. To remove the subframe, you will need a hydraulic jack with sufficient travel and several sets of special equipment - make sure you have all the necessary...

Removal, check and installation of shock-absorbers of a back suspension bracket
Note: To maintain vehicle stability and handling characteristics, rear shock absorbers should be replaced in pairs. Different types of shock absorbers are...

Removal and installation of helical springs of a back suspension bracket
Note: Springs should be replaced as a set. Depending on the model, springs of the appropriate stiffness are installed - use only springs approved for this...

Removal and installation of the rear hub assembly and wheel bearing
CORSA C models with drum brakes Note: The function of the hub on these models is performed by the brake drum into which the wheel bearing is pressed. 1. Remove...

Wheel alignment — general information
General information 1. The geometry of the suspension and its rigidity determine the possibility of limiting the vertical movements of the body and reducing...