Starting the engine and driving Preparing for a car trip Before starting the engine and moving the vehicle, always make an external visual inspection of it. Make sure that the movement of the...
Driving vehicles with automatic transmission (AT) General information Attention: Automatic transmission is a very complex system in its technical execution - independent attempts to interfere in its operation...
Driving vehicles with an Easytronic robotic gearbox The automated 5-speed Easytronic transmission allows manual or automatic shifting, with both modes providing automatic clutch control. Engine start See Section...
Special Driving Modes On models equipped with AT / Easytronic, with the appropriate configuration, additional vehicle control modes are available, controlled by electronic...
Vehicle braking General information The principle of operation and design of the components of the brake system are discussed in detail in Chapter 9 this guide. Monitoring the...
Tire pressure monitoring For more information about wheels and tires, see Chapter 1, Section 5 . General information Attention: Incorrect and untimely adjustment of the air pressure in...
Operation of vehicles with a catalytic converter The exhaust system is discussed in detail in Chapter 4 this guide. Attention: The components of the exhaust system can be heated to very high temperatures -...
Features of driving a car with power steering The models covered in this manual may be equipped with an electric power steering to reduce the effort required to turn the steering wheel. The drive of the...
Additional tips for the driver When driving on snow or ice, use special tires or snow chains (unless it is prohibited by law in the region along which the route passes) ( see Chapter 1,...
Economic driving tips Fuel consumption is largely determined by driving style and vehicle operating conditions. In order to reduce fuel consumption, try to adhere to the following...
Trailer towing General information Note: When towing a trailer, the service life of the vehicle and its efficiency are reduced, because. increases the load on the components...