Removing
Remove brake pads.
Drill out the friction linings with a suitable drill.
Remove the drilled rivets from the blocks with a suitable punch.
Installation
Friction linings are available in two sizes 5 mm linings can be installed immediately after riveting 5.6 mm linings must first be adjusted to the size of the worn drum. In general, all linings of one suspension should be changed at once.
Thoroughly clean the surface when flying linings. Do not apply any adhesive between pads and pads.
Rive the lining with a suitable tool.
When riveting new linings, start from the middle.
Install brake pads.
Visitor comments