Car front suspension Opel Kadett D

Front suspension — design description
1 - drive shaft, 2 - internal constant velocity joint, 3 - damping sleeve (silent block), 4 - external hinge of equal angular velocities, 5 - bearing, 6 -...

Removal and installation of an amortization rack
Removing Engage gear, apply handbrake. Loosen the castellated nut on the drive shaft. Attention: The car must be on supports. Otherwise danger of an accident....

Removal and installation of a forward spring
Removing Remove shock absorber. Attention: When disassembling the rack, the spring must be compressed. Never disassemble the strut without compressing the...

Removal and installation of hydraulic shock absorber
Attention: Fichtel &Sachs shock absorbers as well as Delko Products shock absorbers can be installed. When replacing a shock absorber, the new shock absorber...

Shock absorber check
The shock absorber is checked by hand. Stretch and remove shock absorber. The shock absorber should be uniformly hard to remove along the entire length of the...

Removal and installation of a power shaft
Removing Attention: With a high mileage of the car, the old drive shaft should be replaced as a set. Right drive shaft (looking in the direction of travel)...

Hinge and Hinge Cover Replacement
Replace defective hinge cover immediately. To replace the casing, the driveshaft must be removed. If dirt gets into the grease, wash the hinge and lubricate...