Car engine lubrication system Opel Kadett D

Oil Circuit — 1.0/1.2/1.3L Engines
Oil circuit - 1.0/1.2/1.3L engines

Engine oil consumption
Oil consumption takes place in the engine cylinders. There should be no leakage. The oil is used for: Lubrication of rubbing parts heat dissipation Removal of...

Oil filter replacement
Oil and filter changes are carried out every 6 months, but maybe earlier if the mileage is: gasoline engine every 15,000 km, diesel up to 8/86 every 5000 km,...

Oil pressure check
Warm up the engine to an oil temperature of +60°C, coolant +80°C. For 1.2-/1.3-l engines, the oil pressure sensor is located on the right front in the...

Removal and installation of the oil pan
Replacing the oil pan gasket lift the car, see paragraph 26.13 . Drain the engine oil see point 28.2 . After draining, immediately tighten the drain plug with...

Removal and installation of the oil pump (ONS engine)
Removing Remove the oil pan. Remove V-belt. Remove belt pulley. Remove toothed belt. Remove rear wall of toothed belt cover. Using two screwdrivers, press the...

Engine oil temperature measurement
For various adjustment work, it is important to know the exact temperature of the engine oil. The engine oil temperature should be measured in the oil pan at a...

Removal and installation of a forward epiploon of the crankshaft
ONS engine Removing Remove toothed belt see point 1.3 . Loosen the fixing screws of the crankshaft pulley. Attention: To do this, put the car on the handbrake...

Removal and installation of the oil pressure reducing valve
Diesel engines and ONS engines The pressure reducing valve stabilizes the oil pressure. If the oil pressure control pump is on or flashing, the oil pressure is...

Malfunctions of the engine lubrication system
Malfunction Cause elimination After switching on the ignition, the control lamp does not light up No current flowing to the sensor Corroded contacts Defective...