Removing
Disconnect the earth cable from the battery.
Remove air filter.
Remove fuel line.
Remove starter cable.
Remove vacuum hose.
Disconnect cables from carburetor.
Unscrew the 4 screws, remove the carburetor and plug the intake pipe with a clean rag.
Installation
Install the carburetor with a new gasket and tighten the fasteners to 20 Nm.
Secure ropes, electrical cables and hoses.
Connect fuel line. To do this, slide the copper sealing ring onto the hollow screw, slide the fuel line through the hollow screw and put on the second copper sealing ring from the hollow screw. Carefully screw in the hollow screw.
Connect the battery ground cable.
Install the air filter.
Check idle speed and CO content in exhaust gases.
Visitor comments