Mounting suspension gear lever — removal and installation

1. Apply the handbrake. Jack up the front of the car, secure it on axle stands.

2. Above the propeller shaft, disconnect the shift rod from the shift lever by removing the spring clip and removing the pin.

3. Remove the four bolts securing the shift lever to the suspension.

4. Unscrew the rear suspension mount from the bottom and the front from the gearbox (photo).



5. Get a suspension bracket of the holder from under the car.

6. Unscrew and remove the rubber pads. Check their condition and replace as needed.

7. Installation is carried out in the reverse order.