Elements of the car body Opel Omega B2

General description of the body
The Opel Omega car has a load-bearing body. The base of the body, its side parts, roof and rear fenders are welded together. Most body damage should be...

Front bumper — removal and installation
Removing 1. Remove headlight covers. 2. Unscrew the bolts 1 and 2, press out the three expanding clamps 3, unscrewing their rivets with a Phillips screwdriver...

Front bumper pad — removal and installation
Removing 1. Remove the front bumper. 2. Remove the four clamping keys 2, press out the stops 3 and remove the trim 1 from the bumper (see illustration). 3....

Front cross member — removal and installation
Removing 1. Remove the front bumper. 2. Mark the mounting position of the cross member with a marker, and then unscrew the four mounting bolts and remove the...

Rear bumper — removal and installation
Cars with a body «sedan» Removing 1. Unscrew the mounting bolts and remove the retroreflector (see illustration). 2. Unscrew the mounting bolts and wring out...

Fairing — removal and installation
Removing 1. Remove wiper arms 1 and rubber seal 2 from bulkhead (see illustration). 2. Press the glass cover 3 (see illustration 6.1). 3. Unscrew seven bolts 4...

Front fenders — removal and installation
Removing 1. Remove the front bumper. 2. Remove stone protection 5 by unscrewing bolt 1 and squeezing out six expanding latches 2, as well as two latches 3;...

Hood — removal and installation
Removing the hood should be done by two people with an assistant. The hood hinge can be replaced without removing the hood. If the old hood is installed, then...

Door — removal, installation and fitting
Removing 1. Unscrew the bolt of the door opening limiter (see illustration). Attention! When removing the rear side door, knock out the bushing. 2. Disconnect...

Door upholstery — removal and installation
Removal and installation of an upholstery of doors are resulted on an example of a forward door. Removing 1. Remove the tweeter cover 1 by prying with a small...

Door glass — removal, installation and adjustment
Removal and installation of glass are shown on the example of cars with power windows. Windows with manual power windows are removed and installed in the same...

Door handles — removal and installation
Removing 1. Remove the door upholstery. 2. Detach the protective film near the door handle. 3. Remove facing of the lock of a door. 4. Unscrew the nuts 9...

Door lock — removal and installation
Attention! If the central locking motor and the door lock were separated during disassembly, then the motor must be correctly adjusted during installation....

Center console — removal and installation
Removing 1. Move the front seats forward. 2. Unscrew the bolts of the armrest on the center console (see arrows in illustration). 3. Disconnect the plug 2 of...

Tailgate — removal and installation
Removing Attention! To facilitate subsequent installation, it is recommended to tie twine to the wires and hoses, which will remain in the door cavity. 1....