Removing
1. Remove the rear suspension assembly as described in Chapter 17.
2. Detach the anti-roll bar clips from the rear cross member and remove them.
3. Turn off mounting bolts of the block of the main transfer and remove the block from a back cross member.
4. Loosen and remove the diagonal arm pivot bolts. Note that the bolt heads are facing each other. Remove the rear cross member.
5. If necessary, replace fasteners (see Chapter 19).
Installation
6. Install in reverse order. Tighten all nuts and bolts with a tightening torque specified specifications. When tightening the hinge bolts, the diagonal arms must be horizontal.
Visitor comments