Diesel engines 2.0 liter car Opel Omega B2

2.0 liter diesel engine specifications
Tightening torques for threaded connections, Nm Bolts of fastening of a cover of the block of damping of torsional fluctuations — 8 Starter mounting bolts - 45...

Engine — removal and installation
Attention! The procedure for removing the engine from the engine compartment and its installation is given on the example of a car with a Y22DTH engine and a...

Cylinder head cover — removal and installation
Removing 1. Disconnect the wire terminal from the battery «masses» (-). 2. Remove the protective cover from the engine and disconnect the crankcase ventilation...

TDC of the piston of the cylinder No. 1 — installation
1. Remove the cylinder head cover ( see relevant chapter ). 2. Remove the vacuum pump ( see relevant chapter ). 3. Cars with air conditioning. Disconnect the...

Cylinder head — removal and installation
Removing Attention! The cylinder head should only be removed from a cold engine. 1. Cars with air conditioning. Disconnect the A/C compressor and secure it to...

Cylinder head — bulkhead
1. Remove the cylinder head ( see relevant chapter ). Attention! Place the removed head on wooden blocks so as not to damage the nozzles, glow plugs and...

Camshaft — removal and installation
Removing 1. Set the piston of cylinder No. 1 to TDC by following the steps outlined in the appropriate chapter. 2. Remove tensioner 1 of the timing chain,...

Vacuum pump — removal and installation
Removing 1. Remove the windshield wiper motor, see relevant chapter . 2. Disconnect the low pressure hose from the vacuum brake booster by disconnecting the...

Timing cover — removal and installation
Attention! Dismantling the casing of the gas distribution mechanism is necessary when performing the following work: removal and installation of sprocket 1 of...

Oil pump — removal and installation
Removing 1. Remove the timing cover ( see relevant chapter ). 2. Remove cover 1 of the oil pump located under the casing of the timing gear (see illustration)....

Crankshaft — removal and installation
Removing 1. Remove the power block from the engine compartment ( see relevant chapter ). 2. Disconnect the manual transmission from the engine. 3. Remove the...

Crankshaft — checks
Checking the axial movement of the crankshaft 1. Fix on the block of cylinders the holder with the pointer indicator MKM-571-B, the contact pin of which should...

Connecting rod and piston group — removal and installation
Removing 1. Remove the engine ( see relevant chapter ) and install it on the stand. 2. Remove the vibration damping block ( see relevant chapter ). 3. Remove...

Flywheel — removal and installation
Removing 1. Remove the gearbox and clutch ( see relevant chapter ). 2. Lock the flywheel with thrust shoe 1 KM-652, unscrew the fastening bolts and remove it...

Rear crankshaft oil seal — removal and installation
1. Remove the flywheel from the crankshaft ( see relevant chapter ). 2. Using a suitable tool, press gland 1 out of the holder, taking care not to damage the...

Vibration damping unit — removal and installation
Removing 1. Remove the oil pan ( see relevant chapter ). 2. Unscrew the crankshaft position sensor 1 from the cylinder block together with the O-ring (see...

Auxiliary drive ribbed belt — removal and installation
Removing 1. Remove the mudguard (protection) engine. 2. Mark the direction of rotation of the ribbed belt by marking an arrow on it with chalk. 3. Turn the...

Oil pan — removal and installation
Removing 1. Disconnect the wire terminal «masses» (-) from the negative pole of the battery. 2. Remove the windshield wiper motor ( see relevant chapter ). 3....

Compression — check
1. Remove glow plugs. 2. Disconnect plug 1 of the wiring harness from the injection pump control unit by pushing it in the direction of the arrow (see...