Removing
1. Apply the handbrake, then jack up the front of the vehicle and place it on axle stands.
2. Pull out the mounting brackets, then separate the stem from the transmission and drive mode selector lever and remove it from under the car (see illustration). Remove the bushings installed on the pivot pins of the lever and replace them if they are worn or damaged.
Installation
3. Apply some multipurpose grease to the stem pivot pins. Place the bushings in the operating position, then connect the stem to the transmission and drive selector lever and attach it with brackets.
4. Check the action of the driving mode switch rod and, if necessary, adjust it as described in Chapter 3. When finished, lower the car to the ground.
Visitor comments