Car manual gearbox Opel Omega B2

Manual Transmission Specifications
Tightening torques for threaded connections, Nm Box cover and clutch disc - 5 Output shaft flange - 150 Starter to gearbox Diesel vehicles - 40 Gear shift...

General description of mechanical transmission
1. The transmission is housed in an aluminum alloy cast crankcase bolted to the rear of the engine. The drive to the input shaft of the transmission is...

Transmission Oil — Draining, Filling the Block and Measuring the Level
Note: Manufacturers use three different types of manual transmission oil. Because different types of oil must not be mixed, it is critical to fill the block...

Shift Rod — Adjustment
Note: You will need a special tool Opel KM-631 A. 1. Adjustment of the shift rod is required only after it has been removed. If the newly installed linkage is...

Shift rod — removal and installation
Removing Gear lever 1. Apply the handbrake, then jack up the front of the vehicle and place it on axle stands. 2. Remove the brackets securing the protective...

Oil seals — replacement
Cardan shaft flange seal 1. See Section 8 and unfasten the front end of the propeller shaft from the flange, then remove the vibration damper (where...

Reversing light switch — service check, removal and installation
Health check 1. The reversing light circuit is closed by a plunger-type switch that is screwed into the rear of the transmission, above and to the left of the...

Transmission — removal and installation
Removing 1. Disconnect the negative cable from the battery. Note: On models with the Opel anti-theft system (ATWS) You must remove the negative cable from the...

Transmission Overhaul — General Description
1. Repairing a manual transmission is a difficult task for a novice auto mechanic. In addition to having to remove and install a large number of small parts,...