Car rear suspension Opel Frontera A (petrol)

Rear wheel suspension and rear axle — general information
There are two rear suspension designs available for the Frontera. The car until the middle of 1995 release has a rigid axle on flat springs and hydraulic shock...

Removal and installation of the axle housing (suspension on flat springs)
In the description below, a distinction must be made between vehicles with flat-spring suspension and coil-spring suspension. First you need to find out what...

Removal and installation of the axle housing (suspension with coil springs)
Removing 1. Unscrew the cap of the brake fluid reservoir, close the hole with polyethylene and wrap the cap again. This prevents most of the oil from escaping...

Removal and installation of a helical spring
When carrying out the work described below, the rear of the vehicle must be raised and securely fastened to the stands. Wheels are removed if necessary....

Removal and installation of the shock absorber
Removal and installation of a shock absorber with coil spring suspension is not difficult. Removing 1. To do this, it is necessary to raise the axle with a...

Removal and installation of the longitudinal suspension arm
Work is carried out in accordance with the illustration. Removing 1. Take out the bracket (1) and disconnect the parking brake cable. 2. Disconnect the...

Removal and installation of the average lever
Details of fastening of the average lever are shown on an illustration. Removing The lever is removed as follows: 1. Loosen the mounting bolt (2) and...

Removal and installation of the transverse torque rod and rubber bushings
The transverse torque rod is removed in accordance with the illustration. Before removing, it is recommended to carefully read the design of the traction...

Removal and installation of the stabilizer bar
The anti-roll bar connecting rod is visible in the center of the illustration. To remove the rear of the car must be raised. The bolts securing the connecting...

Rear suspension on leaf springs — removal and installation
The following describes all the work carried out with the type of suspension in question. For most work, the rear of the vehicle should be raised and placed on...