Removal
1. Disconnect the wires from the battery.
2. Unscrew bolt 1 of the clamp (Fig. 3.101). Disconnect air duct 2 from the charge air cooling radiator.
3. Disconnect wiring connector 3 from the air flow meter, pipeline 4 from the turbocharger, unscrew bolts 5 securing the air filter housing and remove the air filter (Fig. 3.83).
4. Disconnect wiring connector 6 from the pressure sensor (Fig. 3.106).
Fig. 3.106. Disconnect wiring connector 6 from the pressure sensor.
5. Remove the pressure sensor 7 (Fig. 3.107).
Fig. 3.107. Remove pressure sensor 7.
Installation
6. Replace the sealing gasket. Screw in the sensor and tighten it to 35 Nm. Connect the wiring connector to the sensor.
7. Further installation is carried out in the reverse order of removal.
Visitor comments