Removal
1. Remove resonator 3 with air duct from the air filter (Fig. 2.76). To do this, remove clamp 1 from support bracket 2.
2. Disconnect wiring connector 1 from coolant temperature sensor 2 (Fig. 2.80).
Fig. 2.80. Disconnect wiring connector 1 from coolant temperature sensor 2.
3. Raise the car.
4. Remove the engine protection by unscrewing six bolts 1 (Fig. 2.78).
5. Lower the vehicle.
6. Unscrew the coolant temperature sensor 1 from the cylinder block (Fig. 2.81).
Installation
7. Installation is carried out in the reverse order of removal. The tightening torque of the coolant temperature sensor is 33 Nm.
Fig. 2.81. Unscrew the coolant temperature sensor 1 from the cylinder block.
Visitor comments