Removing
Measure the thread length of the cable end to the clutch release lever and record the measured value.
Unclip the clamp with a screwdriver.
Rotate the clutch release lever and remove the cable.
Remove the recoil spring and cable from the clutch pedal.
Pull the cable out of the front panel of the body from the side of the engine compartment.
Installation
Route the clutch cable through the front body panel.
Attach the cable to the clutch pedal. Check the correct position in the guides.
Install the retract spring.
Insert the clutch cable into the support and lead it to the clutch release lever at the gearbox.
Attention! When replacing the cable, adjust the nut of its tip to the previous protrusion length of the threaded part.
Adjust clutch.
Visitor comments