Removing
1. Remove the gearbox.
2. Unscrew the union nut and disconnect the hydraulic pipe from the clutch cylinder (A). Unscrew the three fixing screws (IN) and remove the clutch slave cylinder from the transmission input shaft. Remove the sealing ring.
Installation
1. Check that the mating surfaces of the clutch slave cylinder and transmission case are clean and dry, and install a new O-ring in the transmission groove.
2. Lubricate the clutch slave cylinder with oil and install it in place by sliding it over the gearbox input shaft. Check that the O-ring is in the groove of the gearbox housing and secure the slave cylinder with bolts.
3. Connect the hydraulic pipe to the clutch slave cylinder.
4. Install the gearbox.
Visitor comments