Removing the front seat
Move the seat forward.
Pry out the cover at the bottom of the seat belt with a wide screwdriver.
Unscrew the fixing bolt of a seat belt located under it.
Unscrew both guides behind the seat from the bottom of the car.
Unhook the seat console in front.
Tilt the front seat slightly and remove the connector block at the front of the seat. Remove the front seat from the vehicle.
Before mounting the seat, re-cut the threaded holes in the metal of the bottom with an M8 tap and then lubricate with protective mass.
Screw the seat with new bolts to the bottom of the car (20 Nm).
Fasten the seat belt with a new bolt (20 Nm).
Removing the headrest
Pull the headrest all the way out.
Press both release buttons in the seatback and simultaneously pull the headrest out of the backrest.
When installing, push the head restraint until it locks into place.
The rear headrests are removed in the same way.
Removing the rear seat
Seat cushions: Move the front seats forward.
Pull the tab and fold down the corresponding seat cushion.
Ahead on the fingers of the hinges, wring out the retaining rings with a screwdriver.
Remove the hinge pins and remove the seat cushions.
Back: Tilt both seat cushions forward.
Unhook the belt buckles.
Unhook the side mounting lugs with a wide screwdriver.
Unlock at the top of the backrest and lower.
Remove the upholstery corners on the outside of the backrest. To do this, grab the upholstery from behind with both hands and wring out the spring clips.
Remove the torx head bolts underneath.
Unscrew the hinge in the middle in front and behind from the metal of the bottom.
Take the backrest out of the car.
Removing the back pocket on a model with a stepped back
Lower the seat back.
Unscrew the left and right belt adjustment from the inner upholstery.
Take out from clips lateral details of an internal upholstery. Remove the seat belt from the interior upholstery.
Where present, remove the head restraints from the guide sleeves.
Unhook the back pocket at the front.
Press out the five clips on the back of the back pocket.
Remove the rear pocket from the vehicle.
Left: after the corners of the upholstery are wrung out, the backrest can be unscrewed from the hinges.
On right: The photo shows the fixing screws inside (arrows) backs.
Visitor comments