Comment. The operation is shown on the example of replacing the power window regulator. Replacing a manual window regulator is carried out in the same way (there are minor differences, see text).
To perform the work, you will need a drill, a drill with a diameter of 10 mm, a riveter, rivets with a diameter of 5.2 mm.
Execution sequence
1. We prepare the car for work (see «Preparing the car for maintenance and repair»).
2. Remove the front door glass (see «Front door glass - replacement»).
3. If power windows are installed, disconnect the wiring harness block from the gear motor.
4. We drill with a drill with a diameter of 10 mm six rivets for fastening the power window mechanism.
5. Move the window regulator up a little to remove the mounting bracket from engagement with the door panel...
... then we remove the window lifter through the lower technological opening of the front door.
6. If the gearmotor is defective, it can be replaced separately. To do this, use the TORX T30 key to unscrew the three bolts of its fastening to the power window mechanism.
7. We install the parts in the reverse order.
Visitor comments